[hr_shadow]
Hi Keith,
Unfortunately, it’s not a question I would be able to answer. There are people better experienced than me in this area. Please consider asking the question in one (or both) of the following areas:
Or the LCGB Club and under this area (Pre 57)
If you do not use Facebook or can’t post on the LCGB Forum page, let me know and I will raise the question for you.
I hope that this is of some help.
Kind regards
John
Lambretta Journey
Subject: Lambretta ld Torsion bar tolerances
Message Body:
Hi John
Would you know the sizes and tolerances of the Torsion bar to the Torsion bar bush. I know the bush size Should be 32 mm inside diameter.
My bush is oval and oversize 32.1/32.6 the Torsion bar shaft is 31.8 In you experience what should the sizes be. I know I can purchase a new bush but that would still give me a clearance of 0.2mm which may be ok for what it does. I look forward to hearing from you.